Rio Seio Wave W120 Wave Pump W Remote

Introduction

Rio Seio Wave W120 Wave Pump with Remote Control

Flow Rate: 6000 13000L/H
The SEIO Wave pumps are the very latest in high output multi-function wave pumps for reef aquariums. The pre-programmed remote control has 9 pre-set functions as listed below. This is a wave pump that not only promises a lot, it delivers it too!
SEIO W90 Wave Pump specifications:
Pump Size (Approx.) 14cm x 7cm x 8.3cm
Flow Rate 6000-13000 L/H
Optimum aquarium length for wave effects 48″ (120 cm)
Pre-set functions:
1. STANDARD: Water flow can be varied from 6000 L/H to 13000 L/H by using the flow control buttons.
2. RANDOM: Water flow will start at 6000 L/H and gradually increase to the maximum flow of 13000 LPH. Approximate cycle time in 21 seconds: 555-3-3 and will continue to repeat the cycle.
3. FAST RANDOM: Water flow will start at 6000 LPH and gradually increase to the maximum flow of 13000 LPH. Approximate cycle time in 5 seconds: Flow increases every second and will continue to repeat the cycle.

4. GROUNDSWELL: The pump will create an underwater varied current. Use the flow control buttons to adjust the wave shape.
5. SWELL: The pump will create a surging swell at the waters surface. Use the flow control buttons to adjust the wave shape.

6. SURGE: The pump will create an alternating surge from one side of the aquarium to the opposite side of the aquarium. Use the flow control buttons to adjust the wave shape.

7. TIDAL: Water flow will increase in 5/12 minute increments in the period on one hour and will continue to repeat the cycle.

8. NIGHT: Water flow will decrease to 54% of the standard flow rate).

9. FEEDING: Water flow will decrease, then after 20 minutes will go back to the original setting.