Mag-Flip-001 Replacement Scraper for glass aquariums

Introduction

Replacement Scrapers for glass aquariums.
Contains 3 scrapers
Fits the Flip-100 and Flip-200(not yet available)

MAG-FLIP STEP 1
Put the thin part of the Mag-Flip into the aquarium at the front window with the cleaning material in sight. This part will sink to the bottom slowly with the scraper downwards. Put the handle on the outside in front of inner part with logo on top. The magnets attract.
MAG-FLIP STEP 2
To flip the inner unit, completely remove the handle from the window at least 5″ or 10 cm and rotate it 180 degrees (logo up to logo down).
MAG-FLIP STEP 3
Place the handle back on the window about 2″or 5 cm on either side of the inner unit. IMPORTANT: Make sure the top of the handle is at same level as the top of the inner unit.
MAG-FLIP STEP 4
Slide the handle towards the inner unit until flipping occurs. Make sure the top of the handle is at the same level as the top of the inner unit. To flip again start at step 2.